– 24 –
CAUTION:
Use only a rubber mallet, dead blow
hammer, or impact wrench to remove the hub nut.
Use of a steel head hammer may result in damage
to the spin basket.
Note:
The word “LOOSEN” and an arrow appear on
the hub nut. Turn clockwise to remove.
Remove the left-hand thread, 1-11/16" nut
using an impact wrench or a hub nut wrench
(WX5X1325) and rubber mallet or dead blow
hammer.
9.
The hub nut must be torqued to 110 ft.-lbs. To
ensure the hub nut is tightened sufficiently, use an
impact wrench.
(Continued next page
)
Remove the water pressure switch hose from
the outer tub.
Pinch off the black sump hose to prevent water
spills.
Loosen the 5/16" screw-type hose clamp and
remove the sump hose at the tub.
12.
13.
14.
Disconnect
Platform Ground Wire
WARNING:
Exposed terminals, inverter board and
rotating parts may cause injury and/or electrical
shock. To reduce the risk of electrical shock,
disconnect power and allow at least 30 seconds
for capacitors to discharge before servicing motor.
A distinct click can be heard from the relay on the
inverter when the capacitor is discharged.
Disconnect the 2 outer motor harness
connectors, and the 1/4" hex-head screw that
attaches the platform ground wire.
Release the compression tabs that attach the 3
motor wire harness retainers to the front of the
platform.
10.
11.
Wire Retainer (1 of 3)
