GE Vivid in, Service Manual

Page: 285 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 4 - General Procedures and Functional Checks 4-37
Section 4-4
System Turnover Checklist
Before returning the Vivid i n/ Vivid q N ultrasound scanner to regular operational use, the System
Configuration settings should be checked. In 2D-Mode, press
Config
on the keyboard and check the
settings in accordance with those listed or referenced in Table 4-26 below
4-4-1 Software Configuration Checks
Table 4-26 Software Configuration Checklist
Step Task Check
1
Check the date and time settings. Refer to Date and Time Adjustments on page 3-71 .
2
Check the language settings.Refer to Language Selection on page 3-72 .
3
Ensure that all of the software options are configured correctly. Refer to Software Options
Configuration on page 3-84 .
4
Ensure that the hospital details are configured correctly. Refer to Table 3-7 on page 3-70.
5
Ensure that the VCR is configured as required for the specific site and country. Refer to video
converter setup - see
Figure 3-45 on page 3-48 .
6
Ensure that the measurement units are configured as required for the specific site and country.Refer
to
Units of Measure on page 3-74 .
7
Ensure that the connectivity network settings have not been modified and are configured as required
for the specific site. Refer to
Set the Scanner’s Network Information on page 3-99 .