12
49-2000742 Rev. 0
Installation
CONNECT VENT SYSTEM
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover
bracket with 4 - assembly screws provided with
the Recirculation Kit.
2. Measure from the bottom of the air deflector to
the bottom of the hood outlet.
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over
the exhaust outlet from the hood.
7. Reassemble the air deflector to the duct cover
bracket with 4 assembly screws.
8. Seal connections with vent clamps.
COMPLETE INSTALLATION
1. For non-vented (recirculating) installations only,
install charcoal filters over metal grease filter. See
the Care and Cleaning section.
2. Install metal filters. See the Care and Cleaning
section.
3. Check the operation of the range hood blower
and light. See the Using the Hood section.
NOTE:
To get the most efficient use from your new
range hood, read the Using the Hood section.
MAKE ELECTRICAL CONNECTION
Plug into a grounded 3-prong outlet.
Assembly Screws
Duct Cover Bracket
Air Deflector
Air Deflector
Vent
Clamp
Vent
Duct
Exhaust
Outlet
X = length to
cut vent duct
WARNING
ELECTRICAL SHOCK
HAZARD
Plug into a grounded 3-prong outlet
Do not remove the ground prong
Do not use an adapter
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
INSTALLATION PREPARATION
Summary of Contents for UVW7241SNSS
Page 15: ...49 2000742 Rev 0 15 Notes ...
Page 31: ...49 2000742 Rev 0 15 Notas ...
