GE T1000, Technical Manual

Page: 205 / 302

Chapter 7
– Configuration
GE Reason Switches
REASON SWITCHES-TM-EN-3 205
o
Specific : only ethertype configured will be
used at this QCE, that is, this entry will map
frames based in many parameters including
its ethertype value. Values must be inserted
in hexadecimal format.

LLC : indicates which LLC values will be allowed in
this QCE. When selected, the LLC Parameters will
be displayed. Possible configuration is as follows:
o
DSAP Address : indicates which filter should
be applied based on the Destination Service
Access Point (DSAP) field at the frame.
Possible configuration is as follows:
 Any : indicates that all
incoming frames will be used
at this QCE;

Specific: only DSAP configured
will be used at this QCE, that is,
this entry will map frames
based in many parameters
including its DSAP value.
Values must be inserted in
hexadecimal format.
o
SSAP Address : indicates which filter
should be applied based on the Source
Service Access Point (SSAP) field at the
frame. Possible configuration is as
follows:

Any: indicates that all
incoming frames will be used
at this QCE;
 Specific: only SSAP configured
will be used at this QCE, that is,
this entry will map frames
based in many parameters
including its SSAP value. Values
must
be inserted in
hexadecimal format.
o
Control: indicates which filter should be
applied based on the Control field at the
LLC bytes on the frame. Possible
configuration is as follows:

Any: indicates that all
incoming frames will be used
at this QCE;
 Specific: only Control values
configured will be used at this
QCE, that is, this entry will map