SymNet1
User Manual
10
HyperTerminal
To run HyperTerminal, do the following:
1. Power up the SymNet1.
2. Launch HyperTerminal by selecting
Start
>
Programs
>
Accessories
>
Communications
>
HyperTerminal.
3. Type in
<any name>
in the
Connection description
dialog box and click
OK
.
4. Select the correct COM port and click
OK
.
5. Ensure the port settings are
57600 baud, 8 data bits, 1 stop bit, no parity, and no flow control
. Click
OK
.
6. Enter
?
to display the menu.
7. Press
1
for the network settings.
8. Press
2
to change the network settings.
9. Type
n
to disable DHCP and then press
Enter
.
10. Enter the new IP addresses and then press
Enter
.
Note:
Obtain your network specific IP addresses from your network administrator.
11. After the Gateway address is entered the SymNet1 will reboot.
12. Remove power from the SymNet1 and disconnect the serial cable from your PC.
Summary of Contents for SymNet1
Page 1: ...SymNet1 User Manual ...
Page 8: ...SymNet1 User Manual viii ...
Page 42: ...SymNet1 User Manual 34 ...
Page 48: ...SymNet1 User Manual 40 ...
