9.
Remove the large styrofoam block located under the
drum. Lift up on the drum, tilt the base of the foam
block inwards toward the rear of the washer until free,
then pull the block out.
10.
Remove and discard the yellow ribbon and label from
the front of the washer.
11.
From the rear of the washer, carefully pull out the
power supply cord through the hole in the backsheet.
12.
Replace the service panel and screws.
Save all bolts, washers, spacers, brackets, clamps, and
blocks for future use.
NOTE:
If you must transport the washer at a later date,
you must reinstall the shipping support hardware to
prevent shipping damage. Keep the hardware in the
plastic bag provided.
13
Installation Instructions
UNPACKING THE WASHER
WARNING:
Destroy the carton and
plastic bags after the washer is unpacked. Children
might use them for play. Cartons covered with rugs,
bedspreads, or plastic sheets can become airtight
chambers causing suffocation. Place all materials
in a garbage container or make materials inaccessible
to children.
1.
Cut the shipping carton along the dotted line at the
base of the unit.
2.
While it is in the carton, carefully lay the washer on its
back side.
3.
Remove the styrofoam base.
4.
Carefully return the washer to an upright position and
remove the carton.
5.
Carefully move the washer to within 4 feet (122 cm) of
the final location.
6.
Remove the following from the back side of the washer:
4 bolts,
4 yellow plastic spacers,
3 metal “P” clamps.
7.
Remove the service panel from the front of the washer.
8. Remove the 4 nuts and 6 large washers that attach the
2 yellow shipping braces to the drum and the base.
Lift up on the drum and remove the braces (a yellow
ribbon surrounds the items to be removed). These
braces must be removed to allow the power supply
cord to be released from the shipping ring.
NOTE:
Failure to remove the shipping braces can cause
the washer to become severely unbalanced.
6
11
BOLT
SPACER
"P" CLAMP
10
8
9
12
7
8
