RT430
RT430-TM-EN-5
29
2. INSTALLATION
2.1
Unpacking
Unpack the unit carefully and make sure all the accessories and cables are put aside so they will not be lost.
Check the contents against the packing list that goes with the product. If any of the content listed are
missing, please contact Alstom (see contact information at the beginning of this manual).
Examine the unit for any shipping damage. If the unit is damaged or fails to operate, notify the shipping
company without delay. Only the consignee (the person or company receiving the unity) can file a claim
against the carrier for shipping damage.
We recommend you keep the original packing materials for eventual future transport.
2.2
Normal Use of the Equipment
In order to maintain the equipment integrity, levels of protection and assure user safety, the RT430 shall be
installed in an enclosed panel with recommended ingress protection rating of IP54 or above.
The enclosing panel shall ensure that the equipment rear connections and sides are unexposed and
protected against impact and water, meanwhile maintaining adequate temperature and humidity condition for
the devices. Furthermore, the equipment shall have all their rear connectors attached, even if not being
used, in order to keep their levels of igress protection as high as possible.
During the normal use of the device only its the frontal panel shall be accessible.
2.3
External Indications
Connections specifications are shown on an external label above the equipment. Serial number and part
number are shown on a label posted on the side of the equipment
Figure 4: Serial Number, Part Number and Equipment Specifications location
