GE PTV15SAMR, Technician Service Manual

Page: 25 / 85

Page 25
VII. ADJUSTMENT
7.1 COMPRESSOR
7.1.1 Role
The Compressor inhales low temp.
and low pressure gas evaporated from
Evaporator of the refrigerator, and
condenses this gas to high temp. and
high pressure gas, and then plays
delivering role to Condenser.
7.1.2 Composition
The compressor is composed of
Compressor Apparatus compressing
gas, Compressor Motor moving
Compressor Apparatus and Case
protecting Compressor Apparatus and
Motor.
There are PTC-Starter, and Over Load
Protector in the Compressor outside.
On the other hand, because the
Compressor consists of 111000 mm
processing precision components and
is sealed after producing without dust
or humidity, deal and repair with care.
7.1.3 Note to Use
i. Be careful not to allow over voltage and
over current.
ii. No Strike:
If applying forcible power or strike
(dropping or careless dealing), poor
operation and noise may occur.
iii. Use proper electric components
appropriate to the compressor.
iv. Note to Keep Compressor:
If Compressor gets wet in the rain and
rust in the pin of Hermetic Terminal, poor
operation and poor contact may cause.
v. Be careful that dust, humidity, and flux
due to welding don’t inflow in Compressor
inside in replacing Compressor. Dust,
humidity, and flux due to welding which
inflows to Cylinder may cause lock and
noise.