6
MAKE ELECTRICAL CONNECTIONS
WARNING:
Switch power off at the service panel and lock the service disconnecting
means to prevent power from being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a tag,
to the service panel.
Place oven on table or platform even with the cutout opening. For a single oven, the platform must support
220 lbs. (99 kg); and for a double oven, the platform must support 400 lbs. (181 kg). Connect the flexible
conduit to the electrical junction box as shown below*. Position the conduit in such a manner that it will lie
behind the unit in a natural loop when the oven is installed. You will need to purchase an appropriate strain
relief clamp to complete the connection of the conduit to the junction box.
* Ovens come equipped with a 40” long conduit. If a longer conduit is desired, there may be one available for
your model. To check availability or order parts, call 1.800.GE.CARES.
7
THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION
NOTE: If residence leads are aluminum conductors, see
WARNING in Section 5, Electrical Requirements.
When connecting to a three-conductor branch circuit, if local codes
permit:
A. Connect the oven ground conductor along with the neutral
(white) lead to the branch circuit neutral (white or gray in
color), using a wire nut.
B. Connect the oven red lead to the branch circuit red lead and
the oven black lead to the branch circuit black lead in
accordance with local codes, using wire nuts.
C. Install proper strain relief clamp.
D. Install junction box cover.
Junction Box
Conduit
Ground
Red
White
Black
Strain Relief Clamp
(not included) Must Be
Used at Junction Box
Place Oven on a
Support to Assist in
Connecting Conduit
Ground
Wire
8
FOUR-CONDUCTOR BRANCH CIRCUIT CONNECTION
NOTE: If residence leads are aluminum conductors, see WARNING in Section 5, Electrical Requirements.
When connecting to a four-conductor branch circuit, if local codes permit:
A. Free the neutral (white) lead from being restrained to any other
wires. If necessary, cut the neutral (white) lead and then re-strip
it to expose the proper length of conductor.
B. Attach the appliance grounding lead (green or bare copper) in
accordance with local codes.
C. Connect the oven neutral (white) lead to the branch circuit
neutral (white or gray) in accordance with local codes, using a
wire nut.
D. Connect the oven red lead to the branch circuit red lead and the
oven black lead to the branch circuit black lead in ac cor dance
with local codes, using wire nuts.
E. Install proper strain relief clamp.
F. Install junction box cover.
9
SLIDE OVEN INTO OPENING
• Lift oven into cabinet cutout using the
oven opening as a grip. Carefully push
against oven front frame. Do not push
against outside edges.
Ground and
neutral wires (white)
Tape or Crimp
Neutral wire
connection
Black
Red
Branch
circuit
Alternate
knockout
Range
conduit
snaps
into box
Junction Box Cover
Junction Box Cover
White
Black
Red
Branch
circuit
Ground
wires
Alternate
knockout
Range
conduit
snaps
into box
