GE PSH23PGR Series, Technical Service Manual

Page: 9 / 62

– 9 –
About TurboCool. ™
How it Works
TurboCool rapidly cools the refrigerator
compartment in order to more quickly
cool foods. Use
TurboCool
when adding a
large amount of food to the refrigerator
compartment, putting away foods after they
have been sitting out at room temperature
or when putting away warm leftovers. It can
also be used if the refrigerator has been
without power for an extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and
off at high speed as needed for eight hours.
The compressor will continue to run until
the refrigerator compartment cools to
approximately 34°F (1°C), then it will cycle
on and off to maintain this setting. After 8
hours, or if
TurboCool is pressed again, the
refrigerator compartment will return to
the original setting.
How to Use
Press
TurboCool
. The refrigerator
temperature display will show
TC
.
After TurboCool is complete, the
refrigerator compartment will return
to the original setting.
NOTES:
The refrigerator temperature
cannot be changed during
TurboCool .
The freezer temperature is not
affected during
TurboCool
.
When opening the refrigerator
door during
TurboCool , the fans
will continue to run if they have
cycled on.
About the ice and water dispenser.
(on some models)
To Use the Dispenser
Select
CUBED ICE , CRUSHED ICE
or WATER .
Press the glass gently against the top of
the dispenser cradle.
The spill shelf is not self-draining.
To reduce water spotting, the shelf and
its grille should be cleaned regularly.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser arm for at least two
minutes to remove trapped air from the water
line and to fill the water system. To flush out
impurities in the water line, throw away the first
six glassfuls of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Locking the Dispenser
Press the
LOCK CONTROL
pad for 3 seconds to
lock the dispenser and
control panel. To
unlock, press and
hold the pad again
for 3 seconds.
Dispenser Light
This pad turns the night
light
in the dispenser
on and off. The light
also comes on when
the dispenser cradle is
pressed. If this light
burns out, it should be
replaced with a 6 watt
12V maximum bulb.
Quick Ice
When you need ice
in a hurry, press this
pad to speed up ice
production. This will
increase ice production
for the following
48 hours or until you
press the pad again.
Door Alarm
To set the alarm, press
this pad until the
indicator light comes
on. This alarm will
sound if either door is
open for more than
3 minutes. The light
goes out and the
beeping stops when
you close the door.
Spill Shelf