The display board is mounted to the tabletop by two
Phillips screws.
NOTE:
There are plastic washers on the screws to
insulate the screw head from the board. Failure to
reinstall the washers could result in shorting the display
board.
Removing the board will expose the pad buttons housed
in the tabletop molding. When depressed, these buttons
engage the switches on the board. When servicing the
display, make certain the four buttons are fully seated
before reassembling.
Main Control Board
The main control board is enclosed in a plastic housing
to the right of the compressor.
To access the board, remove the Phillips screw on the
left side of the housing and slide left to disengage the
two mounting tabs. Pull the entire housing out and open
the cover by removing the two Phillips screws.
CONTROL BOARD
Due to the curved design of the tabletop, the buttons are
different heights and can be installed backwards. Make
certain to install the connecting bar towards the top of
the table.
CORRECT
INCORRECT
INLAY
NOTE:
The display inlay is glued to front of the tabletop.
If the top requires replacement, make certain to order a
new adhesive inlay.
CONNECTING
BAR
CONNECTING
BAR
4
Summary of Contents for Profile PWR04FANBB
Page 11: ...NOTE PWR04FANABS used for reference Refer to specific model part list 9 ...
Page 12: ...10 ...
Page 13: ...11 ...