– 52 –
Service Test Mode
The washer control has a service test mode that can be utilized by the service technician in order to test
critical components and to access error codes. This test mode will help the service technician to quickly
identify failed or improper operation of washer components.
Caution: Testing is accomplished through built-in test procedures. Unplugging components for testing can
damage component connections.
The washer must be in idle mode (blue screen is blank), before entering the test mode. Idle mode occurs
when the washer has completed a cycle. If the cycle is interrupted, the washer will drain water when the
power is re-applied. The water level switch must reset BEFORE the test mode can be entered. If water
remains in the washer, manually drain the washer to reset the water level switch. A failed water level switch
can cause an inability to enter the test mode.
Test Mode
Description
t01 Confi gure UI (User Interface)
Allows changing the confi guration of the control for
different models.
t02 Error Codes
Checks for any error codes reported by the controls.
t03 Version Information
Checks the software version.
t04 Vibration Test
Tests the washer vibration by spinning to the extra
high spin speed as fast as possible. Note: No out
of balance detection will be performed here, so the
washer will spin up regardless of the out of balance
that is placed in the drum.
t05 EEPROM Test
Checks the memory on the user interface control
board, then the memory on the Power Board.
t06 UI Test
Verifi es all LEDs operate correctly.
t07 Key Continuity
Verifi es that each key operates correctly.
t08 Pump Test
Test drain pump.
t09 Water Level Sensor
Fills to all 3 levels; then pumps out water.
t10 Temp & Heater
Verifi es that both the Thermistor and Heater work.
t11 Hot Water Test
Verifi es hot water valve turns on/off.
t12 Cold Water Test
Verifi es cold water valve turns on/off.
t13 Tumble Test
Verifi es washer tumbles (i.e., Wash Cycle).
t14 Spin Test
Verifi es washer spins. Note: No out-of-balance
detection will be performed here, so the washer will
spin up regardless of any out-of-balance condition
in the drum.
(Continued Next Page)
To enter the test mode:
To exit the test mode:
Press
1.
P
OWER
button to clear any current cycles.
Note: The display must be blank to proceed.
2. Press E
XTRA
R
INSE
-D
ELAY
S
TART
-E
XTRA
R
INSE
-D
ELAY
S
TART
A washer left in the test mode will exit the test mode
and unlock the door after approximately 30 minutes.
Press P
OWER
button.
