GE Portrait Hub01, User Manual

Page: 103 / 198

Pulse oximetry and pulse rate
●
Always check the patient and the measurement site if the accuracy of the SpO
2
data is questionable.
SpO
2
and pulse rate measurement setup
The following graphic describes the options available for the SpO
2
and pulse rate
measurement setup.
1. Portrait
TM
SpO2 P-SA01 sensor with finger tip probe, suitable for adult and
pediatric patients weighing >30 kg (66 lb)
2. Portrait TM SpO2 P-SP01 sensor with pediatric finger tip probe, suitable for pediatric
patients weighing 15 to 30 kg (33 to 66 lb)
3. Portrait TM SpO2 P-SE01 sensor with sensitive skin finger tip probe, suitable for
adult and pediatric patients weighing ≥10 kg (22 lb)
4. Portrait TM SpO2 P-W01 sensor with wrap finger tip probe, suitable for adult and
pediatric patients weighing ≥10 kg (22 lb)
Preparing the SpO
2
and pulse rate connection
1. Select a well-perfused site, and use a non-dominant hand if possible.
2. Clean the application site if necessary (remove nail polish, for example).
Starting the SpO
2
and pulse rate measurement
The following steps describe the high-level sequence of starting the measurement.
Steps 3 to 5 can be done in any order, the sequence given is only an example. See also
the detailed instructions for sensor pairing and patient connections.
1. Admit the patient on the Central Viewer.
2. Select the patient on the Hub.
5815148-01
Portrait ™ Mobile Monitoring Solution
103