– 36 –
Oven Components
(
Continued next page
)
Relay Power Supply Module (RPSM)
To remove the RPSM:
Remove the rear cover. (See
1.
Rear Cover Removal
.)
Note
: In the following step, do not remove the
orange relay jumper wires.
Disconnect the control board wire harnesses
2.
and mark and disconnect wires that connect the
RPSM to the range.
Remove the 5 Phillips-head screws that attach
3.
the RPSM to the relay board frame.
Transfer the relay jumper wires to the
4.
replacement RPSM.
Oven Temperature Sensor
The oven temperature sensor is connected to the
electronic range control
at location J501.
The oven
temperature sensor has an approximate resistance
of:
1080
•
Ω
at room temperature
1654
•
Ω
at 350°F
2650
•
Ω
at 865°F (Clean temperature)
The oven temperature sensor has a resistance
change rate of 2
Ω
per °F.
To remove the oven temperature sensor:
Disconnect power.
1.
Remove rear cover. (See
2.
Rear Cover Removal
.)
Disconnect the sensor wire harness.
3.
Carefully pull the sensor and sensor wiring
6.
harness from the oven liner.
Remove oven racks.
4.
Remove the 1/4-in. hex-head screw that
5.
attaches the sensor to the broiler element
bracket.
Disconnect
Jumper Wire
Jumper Wire
