3
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CENTER BURNER
17,000 BTU/hr Extra Large Burner (PGP976 Models)
13
Installation Instructions
MAKING THE LP CONVERSION
(CONT.)
3
CHANGE COOKTOP BURNER
ORIFICES
A
Remove the grates, burner caps, and burner
heads.
B
Using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
C
Locate the LP orifices attached to the regulator
along with separate LP conversion instructions.
They will have a digit for size and a letter for type
of gas, on the top or side. (Important: Save the
orifices removed from the appliance for future
use.)
Each orifice will show a series of engraved
marks, (I, II, III, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
Retainer
Ring
Burner
Cap
Burner
Head
Set Screw
Choke
Base
Extended
Spud
IV
107 L
Extended spud for center
extra large burner
Orifice spud located
through this opening
NOTE:
On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
I
II
III
IV
x2
x1
x1
x1
x1
x1
x1
I
II
III
V
51L
V
x2
x3
(Shorter)
For PGP976 Models
For PGP986 & CGP650 Models
Burner
cap
Burner
head
Burner
base
Outer
burner
cap
Tri-Ring Burner
Burner
base
Inner
burner cap
Electrode
Burner
base
Orifice spud located
through this opening
Orifice spuds located
through these openings
Electrode
OR
91 L
86 L
86 L
64 L
107 L
IV
91 L
86 L
86 L
64 L
See
Right
Main: 58 L (x3)
Simmer: 51 L
PGP976
CGP650 &
PGP986
