14
Care and cleaning of the refrigerator.
Cleaning the Outside
The dispenser drip area
(on some models)
,
beneath the grille, should be wiped dry. Water
left in this area may leave deposits. Remove
the deposits by adding undiluted vinegar to
the well. Soak until the deposits disappear
or become loose enough to rinse away.
The dispenser cradle
(on some models).
Before cleaning, lock the dispenser by
pressing and holding the
Lock Controls
pad
for 3 seconds. Clean with warm water and
baking soda solution – about a tablespoon
(15 ml) of baking soda to a quart (1 liter)
of water. Rinse thoroughly and wipe dry.
The door handles and trim.
Clean with
a cloth dampened with soapy water.
Dry with a soft cloth.
Keep the outside clean.
Wipe with a
clean cloth lightly dampened with kitchen
appliance wax or mild liquid dish detergent.
Dry and polish with a clean, soft cloth.
Do not wipe the refrigerator with a soiled
dish cloth or wet towel. These may leave
a residue that can erode the paint. Do not
use scouring pads, powdered cleaners,
bleach or cleaners containing bleach
because these products can scratch
and weaken the paint finish.
Cleaning the Inside
To help prevent odors,
leave an open box of baking soda in the fresh food and freezer compartments.
Unplug the refrigerator before cleaning.
If this is not practical, wring excess moisture out of sponge or cloth when cleaning around switches, lights or controls.
Use warm water and baking soda solution – about a tablespoon (15 ml) of baking soda to a quart (1 liter) of water. This both
cleans and neutralizes odors. Rinse and wipe dry.
Use of any cleaning solution other than that which is recommended, especially those that contain petroleum distillates, can
crack or damage the interior of the refrigerator.
Avoid cleaning cold glass shelves with hot water because the extreme temperature difference may cause them to break.
Handle glass shelves carefully. Bumping tempered glass can cause it to shatter.
Do not wash any plastic refrigerator parts in the dishwasher.
Dispenser drip area
About the ice and water dispenser.
(cont )
Precise Fill
(on some models)
This water dispenser is equipped with a feature called Precise Fill. This
feature allows you to choose a precise amount of water. Units include
ounces, cups, pints or liters.
Models with External Dispensers
Access By:
Home > Precise Fill > Set Amount
Activate By:
Using the arrow buttons to select the desired amount.
Press
MORE UNITS
to select between CUPS, OUNCES, PINTS or LITERS.
Press the cup against the cradle and water will begin dispensing. It
will automatically stop when the amount set has been dispensed.
The display will show there is no water left to dispense, then reset.
NOTE:
Do not leave the dispenser unattended when water is being
dispensed.
If you would like to stop dispensing water before the specified
amount has been dispensed, just remove the cup from the cradle.
The display will show the amount left to dispense.
Co
ns
um
er
S
up
po
rt
Tr
ou
bl
es
ho
ot
in
g T
ip
s
Op
er
at
in
g I
ns
tru
ct
io
ns
Sa
fe
ty
In
st
ru
ct
io
ns
In
st
al
la
tio
n I
ns
tru
ct
io
ns
