12
49-1000702 Rev. 1
Installation Instructions
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
/RQJOHQJWKVRI'&YROWDJHVXSSO\OLQHVFRPELQHG
with small gauge wiring can lead to excessive voltage
drop at the refrigerator connection which decreases
the cooling performance of the refrigerator and cause
the wires to overheat possibly causing a fire. The
EHORZVXSSO\ZLUHVL]HLVUHFRPPHQGHG
1. Before beginning the installation, disconnect power
by removing refrigerator circuit fuse or turning off
FLUFXLWEUHDNHULQWKH'&YROWDJHGLVWULEXWLRQSDQHO
2. Locate and remove the screws of the lower rear
unit cover as indicated using a Phillips screwdriver.
3. Locate the power supply connection terminal block
on the left side of the compressor compartment.
WARNING
ELECTRICAL SHOCK
HAZARD
)DLOXUHWRIROORZWKHVHLQVWUXFWLRQVFDQUHVXOWLQ
death,fire, or electric shock.
Supply
Wire Size
Maximum Supply
Line Length
12 AWG
)7
$:*
)7
8 AWG
)7
8QVQDSWKHFOHDUSODVWLFFRYHUIURPWKHWHUPLQDO
block to access terminal screws. Loosen the supply
side terminal screws on the lower side of the block
with a Phillips screwdriver. Attach supply wires to
the appropriate polarity and ground terminals, then
replace clear plastic cover:
&RQQHFWWKHWHUPLQDOWRSRVLWLYH9'&ZLUH
&RQQHFWWKHWHUPLQDOWRQHJDWLYH9'&ZLUH
&RQQHFWWKH*1'WHUPLQDOWR59FKDVVLV
5. A wiring strain relief clip must be installed for the
VXSSO\ZLUHV)URPWKHVHOHFWLRQRIZLUHFOLSV
SURYLGHGVHOHFWWKHDSSURSULDWHVL]HFOLSQHHGHGWR
fit the supply wires used.
8VHWKHVFUHZSURYLGHGWRPRXQWWKHVWUDLQ
relief clip on the base plate of the compressor
compartment. The wires must be completely snug
after clip is installed with no movement or slippage
of the wires within the clip when the wires are
tugged.
5HSODFHWKHUHDUXQLWFRYHUURXWLQJWKHVXSSO\
wires through the opening provided.
8. Move unit into its final position taking care not to roll
over or damage the main power supply line.
$IWHUFRPSOHWLQJLQVWDOODWLRQHQHUJL]HWKHDSSOLDQFH
by replacing refrigerator circuit fuse or turning on
FLUFXLWEUHDNHULQWKH'&YROWDJHGLVWULEXWLRQSDQHO
+
-
GND
Power Input:
DC 12V (10.8-14V)
Current: 20A MAX
