GE PACSystems, User Manual

Page: 26 / 48

3.3 Mounting and Installation
The RXi Display is installed as a panel mounted operator interface. One person can install
the display without the use of any special tools.
Caution
Mount the RXi Display on a flat surface in a
UL/NEMA Type 1 enclosure.
Attention
The cooling fins on the back of the RXi Display must
be vertical. The unit can only be mounted with the
front display connectors oriented down.
➢ ➢
To install the display panel
1. Check the bezel gasket for damage, and replace if necessary.
2. Swing the eight levers on the back of the RXi Display to their retracted position, held
in place by a ball plunger.
3. From the front of the enclosure, tilt the RXi Display into the enclosure opening and
rest its two lower brackets on the enclosure opening bottom edge.
4. Push the top of the RXi Display towards the enclosure until the top latch catches the
enclosure opening top edge.
5. Swing out the eight levers to rest against the enclosure wall.
6. Using a #2 Phillips screwdriver, tighten the lever screws to 0.79 Nm (7 in-lb) using
the tightening order illustrated in the following figure.
26 GFK-2898B PACSystems 19" RXi Display
For public disclosure