Page 18
NX1448E Icon Keypad
When all icons are all illuminated = code is blank; when all
icons are off = “0”.
Use the [
•
] and [
–
] keys to view the next digit or enter new
4- or 6-digit “user code”.
While using the [
•
] and [
–
] keys, you can change any digit
by entering a new digit. This will advance you to the next
digit.
To delete a user code, enter [
r
]-[
r
]-[
r
]-[
r
] for a 4-digit code,
or [
r
]-[
r
]-[
r
]-[
r
]-[
r
]-[
r
] for a 6-digit code.
Step 6 The
ready
icon will flash indicating you are back at Step 2 above.
If the code is rejected, the sounder will beep 3 times.
Step 7 If another “user code” needs to be programmed, return to Step
4.
Step 8 Press the [
#
] key while the
ready
icon is flashing to exit the User
Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user
codes before assigning authority levels.
Step 1 Press [
r
]-[
6
]-[“
Master Arm/Disarm Code
”].
N
Someone changing the authority of another person can
only add or remove partition authorization for
partitions to which they have access.
Step 2 The
ready
icon will flash.
Step 3 Enter the 2 digit “user number” to be assigned authority (The
ready
icon is constant and the
instant
icon will flash).
Step 4 Icons illuminated indicate the authority levels assigned to this
code. An explanation of the icons is listed in the following table.
You may toggle (turn on/off) the authority level by pressing the
number for that authority level.
