GE NetworX NX-1192E, User Manual

Page: 20 / 35

18
2. Enter a MASTER CODE. The LCD screen will prompt for a user number.
3. Enter the 2-digit (applies to NX4/6/8) or 3-digit (applies to NX8E) user number.
Always use leading zeros when necessary, i.e. "004" for user number 4. The
LCD will now prompt you for the attributes in the following chart.
PROMPT
Outputs used?
ž
DO NOT CHANGE THIS SEGMENT!
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
(These are for use by a professional installer only.)
Master code?
Sched arm only?
Arm only?
Reserved
0=No 1=Yes
Your keypress will apply to the user code you entered in
Step 3.
Output 4 ?
Output 3 ?
Output 2 ?
Output 1?
If these messages appear on the LCD screen, press
À
until you return to the prompt for the user code or until you
exit this adjust mode.
4. The LCD will now display all of the partitions to which this user has access.
If you wish to remove a partition, press the partition number on the keypad,
and the display will mark that partition with a (-) hyphen indicating access has
been removed. If you wish to re-establish user access to the partition, press
the partition number again.
5. Press
À
to save the data. The LCD will then prompt you for the next user
code.
6. If another user code needs to be programmed, return to Step 3. If not, press
to exit this feature without saving the data.