Installing the IVG-400
If the IVG-400 is connected directly to the vehicle battery, it continues operating
even when the engine is turned off. For example, with a 55AMP/h battery, the
system will continue to function for about 10 hours if the vehicle battery is not
recharged.
If the IVG-400 is connected through the ignition switch, it will only operate when
the ignition is on. Bear in mind, also, that it will take a few minutes for the IVG-
400 to boot up after the ignition is switched on and about 2.5 minutes after the
ignition is switched off.
Installing the IVG-400
To install the IVG-400:
1.
Connect the two side supports (Figure 4) to either side of the body of the
IVG-400, using three screws for each support, as in Figure 5. (The screws
are included with the IVG-400.)
Figure 4 - Side support
Figure 5 - Side supports attached to IVG-400 body
Screw
Side support
IVG-400 body
(upside down)
2.
Place the unit in the desired location and attach it securely by connecting
the side supports to the anchoring surface with two or three screws on
each side. (These screws are not included with the IVG-400.)
IVG-400 Installation Instructions
Page 3 of 7
