GE MDS TransNEXT NET9L, Technical Manual

Page: 30 / 69

30 MDS TransNEXT Technical Manual MDS 05-7280A01, Rev. A
CLI Overview
NOTE
For serial and USB operation, on timeout or logout, the TransNEXT will display an ASCII
banner page followed by a new prompt for “Login:”
After successful login, the “>” command prompt appears where you may configure and manage unit
settings. Help can be requested as follows:
>help
help <name> for help with a specific command
Available commands:
about System information about this device
app Show application image versions
app_ota OTA App reprogramming
authcode Enter device authorization code
bootloader Show bootloader image versions
cfg Configuration database
clear Clear system logs or stats
clos Enter DLINK mode
help Help command
logout Logout of active session
password Change user password
ping Ping a host
reboot Reboot radio
serdump Display serial payload history
setup Disable hopping and enter radio setup mode
show Show various system attributes
uptime Radio uptime
Individual commands have their own help. Enter the command name followed by help as shown in the
examples below:
>
>show help
show device Show device information
show log <debug> Show event log, with optional debug points
show alarms Show current system alarms
show status Show radio status
show stats Show radio and network statistics
show sync Show radio synchronization status
show temp Show system temperature
show vin Show radio input voltage
show uptime Show system uptime
show rssi Show continuous radio RSSI
show rssi! Show radio RSSI
>cfg help
cfg snapshot Save a snapshot of the database
cfg restore Restores saved database snapshot
cfg show Show entire database
cfg load Load database from flash
cfg save Save database to flash
cfg replace Replace database: prompts for multi-line value
cfg get <key> Get value assigned to key
cfg set <key>.<value> Assign value to a key