GE MDS ORBIT MCR, Technical Manual, Page: 57 / 463

MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 57
Example #3
Figure 3-19 shows the Orbit MCR #2 device acting as a terminal server to provide connectivity to the
serial-based SCADA device via UDP.
NOTE
The configuration for Orbit MCR #1 in Figure 3-19. Example 3: Unit Providing Connectivity to
Serial-Based SCADA Device via UD is identical to the configuration shown in the previous
example (Example #2).
Figure 3-19. Example 3: Unit Providing Connectivity to Serial-Based SCADA Device via UDP
The following commands will configure the Orbit MCR #2 for this scenario.
% set interfaces interface
Wi-Fi
type wifi
% set interfaces interface
Wi-Fi
wifi-config mode access-point ap-config ap
myssid
enabled
true
% set interfaces interface
Bridge
type bridge
% set interfaces interface
Bridge
bridge-settings members port
ETH1
% set interfaces interface
Bridge
bridge-settings members wifi-station interface
Wi-Fi
% set interfaces interface
Bridge
ipv4 address
192.168.1.22
prefix-length
24
% set services serial terminal-server server
COM1
mode udp port
30000
remote address
192.168.1.11
port
30001