GE
Direction 5370626-100, Revision18 LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Chapter 1 - Introduction
1-13
Section 1-3
Safety Considerations
1-3-1
Introduction
The following safety precautions must be observed during all phases of operation, service and repair of
this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this
manual, violates safety standards of design, manufacture and intended use of the equipment.
1-3-2
Human Safety
Operating personnel must not remove the system covers.
Servicing should be performed by authorized personnel only.
Only personnel who have participated in a LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid etraining
are authorized to service the equipment.
1-3-3
Mechanical Safety
NOTE:
Special care should be taken when transporting the unit in a vehicle:
•
Before transporting, place the system in its special storage case.
•
Ensure that the system is firmly secured while inside the vehicle.
•
Secure system with straps or as directed otherwise to prevent motion during transport.
•
Prevent vibration damage by driving cautiously. Avoid unpaved roads, excessive speeds, and
erratic stops or starts.
1-3-4
Electrical Safety
To minimize shock hazard, the equipment chassis must be connected to an electrical ground. The
system is equipped with a three-conductor AC power cable. This must be plugged into an approved
electrical outlet with protective ground.
The power outlet used for this equipment should not be shared with other types of equipment.
Both the system power cable and the power connector meet international electrical standards.
1-3-5
Label Location
Please refer to Basic User Manual for label location information.
WARNING
WARNING
Ultrasound probes are highly sensitive medical instruments that can easily be damaged
by improper handling. Use care when handling and protect from damage when not in
use. Do not use a damaged or defective probe. Failure to follow these precautions can
result in serious injury and equipment damage.
WARNING
WARNING
Never use a probe that has fallen to the floor. Even if it looks ok, it may be damaged.
CAUTION
The LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e weights 4.6kg or more, depending on
installed peripherals, when ready for use. To avoid possible injury and equipment damage:
ALWAYS:
•
Use the handle to move the system.
•
Do not let the system strike walls or door frame.
•
Limit movement to a slow careful walk.
Summary of Contents for LOGIQ e R4 Series
Page 271: ......
