
care
cleaning are important so your range
Care of Modules
will give you efficient and satisfactory service.
Follow these directions carefully in caring for it to
Some
the modules must be cured or preconditioned
help assure safe and proper maintenance.
before using them for the first time. Modules and
BE SURE ELECTRICAL POWER IS OFF BEFORE
accessories should be cleaned after each use. The
CLEANING ANY PART OF THE RANGE.
longer a soil remains, the harder it is to clean. See
each module section in this manual for specific
instructions. Never immerse any module in-water. When
not in the maintop, modules and accessories should be
stored in a clean, dry place. Always be careful not to
drop the modules or they could be damaged.
Plug-In Elements of the Open Coil Module
To clean the surface units, turn the control to the
highest setting for a minute. The coils will burn off
any soil.
CAUTION
●
not immerse the surface units or the module in
liquids of any kind.
●
Do not clean the surface units or the
in a
dishwasher.
●
Do not bend the surface unit plug terminals.
not attempt to clean, adjust or in any way repair
the plug-in receptacle or the module.
●
operate a surface unit without the drip pan
in place. This can cause scorching
the module,
burning wire insulation and loss
energy.
To remove the drip pans for cleaning, the surface units
must be removed first. Make sure the surface units are
completely cool before touching them.
Surtace Unit
Drip Pan
Lift the surface unit about inch above the drip
and pull it out.
Do not lift the surface unit more than 1 inch.
[f you do, it may not lie flat
the drip pan when
you plug it back in.
Repeated lifting of the surface unit more
than inch above the drip pan can permanently
damage the receptacle.
To replace a surface unit:
●
Replace the drip pan into the recess in the module.
Make sure the opening in the pan lines up with the
receptacle.
●
Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle.
●
Guide the surface unit into place so it rests evenly.
Drip Pans
the surface units. Then lift out the drip pans.
The drip pans can be cleaned by hand. Place them in a
covered container (or a plastic bag) with 1/4 cup
ammonia to loosen the soil. Then scrub with a soap
filled scouring pad if necessary. Rinse with clean
water and polish with a clean soft cloth.
The drip pans may also be cleaned in the dishwasher.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch fire.
Do not cover drip pans with foil. Using foil so close
to
receptacle could cause shock, fire or damage to
the range.
CAUTION: Be sure all controls are turned to
OFF and surface units are cool before attempting
to remove them.
33
Summary of Contents for JSP60GN
Page 45: ...NOTES 45 ...
Page 46: ...NOTES 46 ...