Units and Drip Pans
To clean the surface units, turn the control to the highest
setting for a minute. The coils will burn off any soil.
CAUTION
●
Be sure all the controls are turned to OFF and
the surface units are cool before attempting to
remove them.
Do not
immerse the surface units in liquids of any kind.
●
Do not clean the surface units in a dishwasher.
●
Do not bend the surface unit plug terminals.
●
Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove a surface unit:
To remove the drip pans for cleaning, the surface units
must be removed first.
Surface Unit
Drip Pan
Lift the surface unit about 1
inch above the drip pan
—-red
it out.
not lift the surface unit more than 1 inch.
If you do, it may not lie flat on the drip pan when
you plug it back in.
Repeated lifting of the surface unit more
than 1 inch above the drip pan can permanently
damage the receptacle.
To replace a surface unit:
●
Replace the drip pan into the recess in the
cooktop. Make sure opening in the pan lines up
with the receptacle.
●
Insert the terminals of the surface unit through
the opening in the drip pan and into the receptacle.
●
Guide the surface unit into place so it rests evenly.
Drip Pans
Remove the surface units. Then lift out the drip pans.
For best results, clean the drip pans by hand. Place
them in a covered container (or a plastic bag) with 1/4
cup ammonia to loosen the soil. Then scrub with a
soap filled scouring pad if necessary. Rinse with clean
water and polish with a clean soft cloth.
The drip pans may also be cleaned in the dishwasher.
Black drip pans (on some models) may be cleaned in
a self-cleaning oven after they have been thoroughly
rinsed. However, self-cleaning them may cause them
to lose their original luster and shine.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch on fire.
Do not cover drip pans with foil. Using foil so close
to the receptacle could cause shock, fire or damage to
the range.
Lift-Up Cooktop
Clean the area under the cooktop often. Built-up soil,
After cleaning under the cooktop with hot, soapy
especially grease, may catch fire.
water and a clean cloth, lower the cooktop. Be careful
To make cleaning easier, the entire cooktop may be
not to pinch your fingers.
lifted up and supported in the up position.
Be sure all the surface units are turned off before
raising the cooktop. The surface units and drip pans
do not need to be removed, however, you may remove
one to make raising the cooktop easier. Dual support
rods will hold the cooktop up while you clean
Rod
underneath
Oven Vent
—
oven is vented through an opening under the right rear surface unit.
cover the opening with aluminum foil or any other material. This
would prevent the oven vent from working properly.