QUESTIONS?
USE THIS PROBLEM SOLVER
—
PROBLEM
POSSIBLE CAUSE
u must
which are absolutely flat, light can be. seen between the
edge, the surface
will not transfer heat properly.
I closely
the diameter
the surface unit selected.
being used. Pan bottoms should be flat, fairly heavy weight
I
the same diameter as surface unit selected.
in distribution panel of your house, caused by a
a
breaker, the main fuse or
m the nature of the power supply. If a
the control box uses fuses, the cooktop
\-
...
changed, BUT ONLY BY SOMEONE
WITH ELECTRICAL CIRCUITS. If after performing one of these
the fuse blows or circuit breaker trips again, call for service.
or condominium owners should ask their building
this check before calling for service.
controls are not properly set, or the wrong control knob
●
cookware with rough bottoms
—
coarse
particles (salt or sand) were between the cookware
surface
the cooktop. Use recommended cleaning procedures, be sure
bottoms and cookware
clean before use, and use cookware with
bottoms. Tiny scratches are not removable but will become less visible
time a result. of cleaning.
slide
cookware across the surface. Use recommended
procedure to remove
cleaning materials
have been used, encrusted
or grease
the surface. Use a razor scraper and recommended
CONTROL KNOB
When the knob is at the OFF position, it must be pushed in before it can be
WILL NOT TURN
turned. When the knob is at any
position, it can be turned without being
pushed in.
—
If you need more help.
toll free:
GE Answer
800.626.2000
consumer information service
14
