– 49 –
Damper Door Switch
The damper door sensing switch is mounted to the
damper assembly. The switch monitors the damper
door position and provides this information to the
main PCB, which controls the operation of the
damper door motor.
When the damper door is closed, the switch is open.
The motor will run until the switch sends the door
closed signal. If the damper door sensing switch
circuit shorts (or opens), the damper motor will run
continually. The damper motor has an approximate
UHVLVWDQFHYDOXHRINű
Damper Door Operating Modes
Cooking
Mode
Damper
Position
Switch
Plunger
Position
Switch
Contacts
Microwave Open
Not
Depressed
Closed
Speedcook Closed
Depressed Open
Magnetron and Magnetron TCO
WARNING: Always be certain the capacitor is
discharged before servicing. (See the Capacitor and
Diode section in this guide.) Mechanically discharge
by placing insulated pliers between the diode
connection of the capacitor and the oven chassis
ground.
NOTE: The capacitor has an internal discharge
resistor that automatically discharges the capacitor
when the oven turns OFF. Under normal operation,
the capacitor should fully discharge within 30
seconds.
The oven must be removed to access the
magnetron. (See the Removing Upper Oven section
in this guide.) The magnetron is located behind the
top access cover. The top access cover is held in
place by two Phillips head screws. The magnetron
is held in place by four Phillips head screws. The
magnetron thermostat must be disconnected
before removing the magnetron.
Magnetron TCO
The magnetron TCO is attached to a bracket
mounted to the magnetron. The magnetron bracket
is held in place by a single Phillips head screw.
This position of the magnetron TCO allows it to
sense the temperature of the magnetron.
The magnetron TCO opens at 302°F and cannot be
reset. If the magnetron TCO opens, it will disable all
oven functions including the display.
Summary of Contents for JK3800DH1BB
Page 58: ...58 Schematic Diagram...
Page 73: ...73 Machine Control Schematic...
