Installation Instructions
INSTALL THE RANGE
(CONT.)
ALTERNATE CONSTRUCTION
PREPARATION (cont.)
FOR CABINET OPENINGS
APPROXIMATELY 30-3/8
″
If range is installed in cabinet opening
approximately 30-3/8
″
, the Vertical Side Trim Kit
(JXS86XX) should be used to cover gaps between
range sides and cabinet. Refer to the kit
instructions for installation details.
D
19
CABINETS OVER THE RANGE LESS
THAN 30
″
If a 30
″
clearance between cooking surface and
overhead combustible material or metal cabinets
cannot be maintained, protect the underside of the
cabinets above the cooktop with not less than 1/4
″
insulating millboard covered with sheet metal not
less than 0.0122
″
thick.
E
OPERATION CHECKLIST
•
Double check to make sure everything in this
guide has been completed. Rechecking steps
will ensure safe use of the cooktop.
•
Make sure all controls are left in the OFF
position.
•
Make sure the flow of combustion and
ventilation air to the cooktop is unobstructed.
•
The serial plate for your Range is located
under the oven door above the storage area. In
addition to the model and serial numbers, it tells
you the ratings of the burners and the type of
fuel and pressure the cooktop was adjusted for
when it left the factory.
•
When ordering parts, always include the serial
number and model number to ensure proper
replacement parts.
•
Recheck Steps: Double check to make sure
everything in this guide has been completed.
Rechecking steps will ensure safe use of the
Range.
20
IN SOME CASES
With L.P. gas, some yellow tipping on the outer
cone is normal.
Foreign particles in the gas line may cause an
orange flame at first, but this will soon disappear.
SPECIAL NOTE:
To convert the oven back to natural gas, reverse the
instructions given in making L.P. Adjustments.
Once the conversion is complete and
checked ok, fill out the LP sticker and include
your name, organization and the date the
conversion was made. Apply the sticker near
the regulator to alert others in the future that this
appliance has been converted to LP gas. If converting
back to natural gas from LP, please remove the sticker so
others know the appliance is set to use natural gas.
B
A
Please see L.P. conversion instructions
supplied with this range when L.P. Gas is used.
NOTE:
Instructions are mounted on regulator
bracket.
ADJUSTING LOW FLAME SETTING
ON COOKTOP BURNERS
Low setting adjustments must be made with two
other burners in operation on a medium setting. This
procedure prevents the low flame from being set too
low, resulting in the flame being extinguished when
other burners are turned on.
Remove the valve control knobs.
Through the opening, locate the valve bypass
screw located on the lower right side of the valves.
Using a small screwdriver, screw down the bypass
screw fully in a clockwise rotation.
C
B
A
16
Printed in the United States