GE JGSP30GER, Use And Care Manual, Page: 9 / 36

OVEN CONTROL CLOCK
Clock
To Set the Clock
The clock must be set for the
automat oven timing functions to
work properly. The time day
be changed during Timed
Bake or CLEAN cycle.
2: Press the
INCREASE or
DECREASE pad
to
set the time of day.
Step 3: Press the CLOCK pad
to start.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does
control oven
operations. The setting
on the timer is hours
55 minutes.
1
Step 1: Press the
TIMER pad.
T I M E R
Step 2: Press the INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will
within few seconds of releasing
the pad.
The timer, as you are setting
it, wil I display seconds until
60 seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
Power Outage?
If “TIMER” is showing, press the
Press the TIMER until the
After power outage, when power
INCREASE or DECREASE
word “TINIER” quits on
is restored, the display will
until desired time is reached.
the 4 seconds).
and time shown will no longer be
“TIMER” is showing, press
correct-for example, after
the TIMER first, then follow
5-minute power interruption the
instructions to set the timer.
clock will be 5 minutes slow.
The
flashes until
the clock
is reset.
-
All other functions that
were in operation when the power
went out will have to be
programmed again.
Display Messages
End of Cycle Tone
If appears on the display, the door is open.
The end of cycle tone is a series of three beeps
Close the door. [f .’LOCK” appears on the display. the
followed by one beep every six seconds. If
YOU
oven door is in the locked position. BAKE, BROIL
like to remove the signal that beeps every six seconds,
and COOK TIME set if the door is in the
press and hold the CLEAR/OFF pad for 10 seconds.
locked position.
To return the signal that beeps every six seconds,
press
hold the CLEAR/OFF pad for I () seconds.
9