42
Installation Instructions
WARNING!
ANTI-TIP DEVICE
All ranges can tip and injury could
result.
To prevent accidental tipping of the range,
attach an approved Anti-Tip device to the
wall. (See
Installing the Anti-Tip Device
in
this section.) To check if the device is
installed and engaged properly, carefully
tip the range forward. The Anti-Tip device
should engage and prevent the range
from tipping over.
If you pull the range out from the wall for
any reason, make sure the Anti-Tip device
is engaged when you push the range back
against the wall.
■
For your safety, never use your range for warming
or heating the room. Your oven and cooktop are not
designed to heat your kitchen. Top burners should
not be operated without cookware on the grate. Such
abuse could result in fire and damage to your range
and will void your warranty.
■
Do not store or use combustible materials,
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
Explosions or fires could result.
■
Do not use oven for a storage area. Items stored
in the oven can ignite.
■
Do not let cooking grease or other flammable
materials accumulate in or near the range
.
LOCATION
Do not locate the range where it may be subject to
strong drafts. Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh air
for combustion and ventilation are not obstructed
by carpeting or woodwork.
Your range, like many other household items, is
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting. Use care when moving
the range on this type of flooring. It is recommended
that the following simple and inexpensive instructions
be followed to protect your floor.
The range should be installed on a sheet of plywood
(or similar material). When the floor covering ends at
the front of the range, the area that the range will rest
on should be built up with plywood to the same level
or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing. Also, make sure your floor covering will
withstand 180°F. (See the
Installation Safety Instructions
section.)
Make sure the wall coverings around your range can
withstand the heat generated (up to 200°F) by the
range. (See the
Installation Safety Instructions
section.)
IMPORTANT!
Remove all tape and packaging. Make sure the
burners are properly seated and level.
Take the accessory pack out of the oven and/or
drawer.
Check to be sure that no range parts have come
loose during shipping.
