(continued)
Surface Units and Drip Pans
To
clean the surface units, turn the control to the highest
To replace a surface unit:
setting for a minute. The coils will burn off any soil.
●
Replace the drip pan into the recess in the
CAUTION
Make sure opening in the pan lines up
●
Be sure all the controls are turned to OFF and
with the receptacle.
the surface units are cool before attempting to
●
Insert the terminals of the surface unit through
remove them.
the opening in the drip pan and into the receptacle.
●
Do not immerse the surface units in liquids of any kind.
●
Guide the surface unit into place so it rests evenly.
●
Do not clean the surface units in a dishwasher.
●
Do not bend the surface unit plug terminals.
●
Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove a surface unit:
To remove the drip pans for cleaning, the surface units
must be removed first.
Unit
\
Drip Pans
Remove the surface units. Then lift out the drip pans.
For best results, clean the drip pans by hand. Place
them in a covered container (or a plastic bag) with 1/4
cup ammonia to loosen the soil. Then scrub with a
soap filled scouring pad if necessary. Rinse with clean
water and polish with a clean soft cloth.
The drip pans may also be cleaned in the dishwasher.
Clean the area under the drip pans often.
Receptacle
Built-up soil, especially grease, may catch on fire.
Drip Pan
Do not cover drip pans with foil. Using foil so close
to the receptacle could cause shock, fire or damage to
Lift the surface unit about 1 inch above the drip pan
the range.
and pull it out.
Do not lift the surface unit more than 1 inch.
If you do, it may not lie flat on the drip pan when
you plug it back in.
Repeated lifting of the surface unit more
than 1 inch above the drip pan can permanently
damage the receptacle.
Clean the area under the
often. Built-up soil,
After cleaning under the
with hot, soapy
especially grease, may catch fire.
water and a clean cloth, lower the
Be careful
To make cleaning easier, the entire
may be
not to pinch your fingers.
lifted up and supported in the up position.
Be sure all the surface units are turned off before
raising the
Grasp the front sides of the
and lift. The surface units and drip pans do
not need to be removed, however, you may remove
Rod
one to make raising the
easier.
Oven Vent
The oven is vented through an opening under the right rear surface unit.
Never cover the opening with aluminum foil or any other material. This
‘
Oven Vent
would prevent the oven vent from working properly.
