Problem
Possible Causes
What To Do
Display flashes “bAd”
The installed connection
•
Contact installer or electrician to correct miswire.
then “linE” with a
from the house to the unit
loud tone
is miswired.
Display goes blank
A fuse in your home may be
•
Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off from
•
See the
Using the clock and timer
section.
showing in the display.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BAKE
and
BROIL
pads must be pressed
display to show “SF”
not pressed properly.
at the same time and held for 3 seconds.
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
OFF
pad, setting the clock and
resetting any cooking function.
“Burning” or “oily”
This is normal in a new
odor emitting from
oven and will disappear
the vent
in time.
Strong odor
An odor from the insulation
•
This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
No power supply from
Small appliance plug is not
•
Make sure the small appliance plug is properly
convenience outlet
completely inserted in the
inserted.
on top of backguard
convenience outlet.
(on some models)
The backguard is too hot
•
Allow the range to cool, then reset the circuit
and the convenience outlet
breaker by pressing the switch located near the
breaker has tripped.
convenience outlet.
www.GEAppliances.ca
29
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Summary of Contents for JCBS55
Page 34: ...34 ...