Installation Instructions
Electrical Connections
cont.
B
B3
Complete 4 wire
cord kit. Below are
step by step
instructions on
how to install the
kit.
B4
Remove the screws on
the terminal block with
a 1/4” nut driver or
phillips screwdriver.
Remove
3 screws
B5
B6
Remove the ground
screw using a 5/16”
nut driver, then
remove and discard
the ground strap.
Do
not discard the
ground screw, you
will need it later.
B7
Install the four-wire
cord and strain
relief through the
hole in the
connection plate.
NEW CONSTRUCTION AND FOUR
WIRE CORD CONNECTION KIT
6
3 Screws
Gound
Screw and
Ground Strap
Location
Strain
Relief
Clamp
Connection
Plate
Knockout in center
of connection plate
may be taken out
B8
Attach the green lead
below the junction
block with the ground
screw that was
removed earlier.
B9
Connect the red
and black leads to
the outside
terminals and the
white lead to the
center terminal.
B10
Push the cord upward (to relieve strain),
while tightening the strain relief clamp.
B11
Re-install the wire cover with the 5
screws removed earlier. Make sure the
wires do not become pinched between
the wire cover and mainback.
Wire
Cover
Three-wire connection continued on following page
Ground
Screw
Ground
Strap
Ground
Screw
Red or
Black
White
Red or
Black
Ground
(Green)
Connection
Plate
Strain
Relief
Clamp
4 wire
cord kit
