Installing the KTD-127W
KTD-125/127 PTZ Receivers User Manual
5.2 M
AKING
C
ABLE
C
ONNECTIONS
See Figure 30 for the following procedures.
Removable terminal strip
Receiver card
Camera power/zoom lens
Pan/tilt
24 VAC in
RS422 control out
RS422 control in
Figure 30. KTD-127W cable routing
To prepare the cables for connection perform the following.
1)
Remove 6 inches of the outer casing of the camera/lens, pan/tilt,
and power cables.
2)
Tie a knot in the RS422 cable(s) six inches from the on the inside
of the housing to act as a strain relief.
3)
Remove the outer casing from the end of the RS422 cable(s).
To make the cable connections perform the following.
1)
Remove the terminal strip from the main relay board.
2)
Make the connections as shown in Figure 31 through Figure 33.
26
1040823A / June 2003
Summary of Contents for Interlogix KTD-125
Page 1: ...KTD 125 125 24 KTD 125P 125P 24 KTD 127 127W PTZ Receivers ...
Page 37: ......
