GE IM4D, Owner'S Manual And Installation Instructions

Page: 20 / 68

20
Installation Instructions
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.
Turn the main water supply on and flush out
the tubing until the water is clear.
Shut the water off at the water valve after about
one quart (1 liter) of water has been flushed
through the tubing.
FLUSH OUT THE TUBING 8
Tighten the clamp screws until the sealing washer
begins to swell.
NOTE: Do not overtighten or you may crush
the tubing.
TIGHTEN THE PIPE CLAMP 5
Washer
Inlet End
Pipe Clamp
Clamp
Screw
Route the tubing between the cold water line and
the refrigerator.
Route the tubing through a hole drilled in the wall
or floor (behind the refrigerator or adjacent base
cabinet) as close to the wall as possible.
NOTE:
%HVXUHWKHUHLVVXIILFLHQWH[WUDWXELQJ
(about 8 feet [244 cm] coiled into 3 turns of about
>FP@GLDPHWHUWRDOORZWKHUHIULJHUDWRU
to move out from the wall after installation.
ROUTE THE TUBING 6
Place the compression nut and ferrule (sleeve)
for copper tubing onto the end of the tubing and
connect it to the shutoff valve.
Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.
For plastic tubing from a GE SmartConnect
™
Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut until it is hand tight, then tighten
one additional turn with a wrench. Overtightening
may cause leaks.
CONNECT THE TUBING TO
THE VALVE
Saddle-Type
Shutoff Valve
Compression
Nut
SmartConnect
™
Tubing
Packing Nut
Outlet Valve
Ferrule (sleeve)
CONNECT THE TUBING
TO THE REFRIGERATOR
9
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
• If your refrigerator does not have a water
filter, we recommend installing one if your water
supply has sand or particles that could clog the
screen of the refrigerator’s water valve. Install it
in the water line near the refrigerator. If using
GE SmartConnect
™
Refrigerator Tubing kit, you
ZLOOQHHGDQDGGLWLRQDOWXEH:;;WR
connect the filter. Do not cut plastic tube to
install filter.
5HPRYHWKHSODVWLFIOH[LEOHFDSIURPWKHZDWHUYDOYH
(refrigerator connection).
7
INSTALLING THE WATER LINE
(CONT.)