Installation Instructions
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the
icemaker
power switch
to
ON
.
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
5
57
ROUTE AND ATTACH THE
PLASTIC WATER LINE
•
Route the plastic water line along the back of
the refrigerator to the water tube inlet.
•
Fasten the
plastic water line
to the back of
the cabinet with three of the
adhesive-backed
fasteners
(5).
4
3
CONNECT THE WATER LINE
•
Make sure there is enough plastic water line to
extend from the water valve to well into the
water
tube inlet
(15). Cut off any excess tubing.
•
Squeeze the ends of the
hose clamp
(3) from the
kit with pliers and slide the clamp over the water
tube inlet.
•
While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1
″
[25 mm]).
•
Then slide the clamp downward to capture the
plastic water line in place.
•
Make sure the fill tube is aimed down.
3
Water tube
inlet
Adhesive-backed
fasteners for
plastic water line
Summary of Contents for IM4
Page 206: ...206 Notas ...