Installation Instructions
ATTACH THE PLASTIC WATER
LINE
Route the plastic water line along the back of the
refrigerator to the icemaker hole in the case back.
Use three of the
adhesive-backed fasteners
(5) to
secure the tube to the case back.
5
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the
icemaker
power switch
to
ON
.
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
6
Adhesive-backed
fasteners for
plastic water line
29
INSTALL WATER LINE CLAMP
•
Push the
metal water line clamp (strain relief)
(12)
onto the lower flange of the cabinet back, directly in
line with the water valve.
•
The metal clamp is for the house water line. (See
the Water Line Installation Instructions). It is not
to be used for the tubing from the water valve up
to the icemaker.
3
12
CONNECT THE WATER LINE
•
Squeeze the ends of the
hose clamp
(3) from
the kit with pliers and slide the clamp over the
water tube inlet.
•
While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1
″
[25 mm]).
•
Then slide the clamp downward to capture the
plastic water line in place.
•
Make sure the fill tube is aimed down.
•
If the condensor mounting screw was removed,
secure the condensor to the refrigerator by
replacing the mounting clip and screw.
DO NOT OVER-TIGHTEN THE SCREW.
4
Water tube
inlet
3
5
Summary of Contents for IM4
Page 206: ...206 Notas ...
