24
INSTALL WATER LINE CLAMP
•
Attach the
metal water line clamp (strain relief)
(8) to the refrigerator. Drive the
screw
(7) from
the kit through the
clamp
(8) at the indent into
the back of the cabinet.
•
The metal clamp is for the house water line (see
the Water Line Installation Instructions). It is not
to be used for the tubing from the water valve up
to the icemaker.
2
Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS H
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
or
R
Q
P
N
M
L
K
J
H
G
F
C
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4
″
and 5/16
″
Nutdriver
ATTACH THE WATER VALVE
•
Locate the
female connector plug
(B).
1
13
•
Plug the
female connector
(B) onto the
male
terminals on the water valve
(4). Either wire
can go on either terminal.
•
Fasten the water valve to the cabinet edge hole
using the
hex-head screw
(13) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
•
Check the
plastic water line nut
on the bottom of
the water valve to be sure it is hand tight. DO NOT
USE TOOLS.
B
B
4
7
8
Summary of Contents for IM4
Page 206: ...206 Notas ...