GE GSS20 Series, Technical Service Manual

Page: 9 / 36

– 9 –
Condenser Fan and Motor
Note: The condenser fan harness is 3 inches
longer to accommodate maintenance.
Removal and Replacement
Remove 6 screws, then remove the cover from
the rear of the refrigerator.
Wheel Assembly
Removal and Replacement
Unplug the refrigerator and lay the refrigerator on
its back side.
Remove 3 screws from the bottom of the wheel
assembly.
Remove the fan motor and disconnect the
electrical connector.
Pull the fan blades off of the end of the fan shaft.
Caution: The grommet in the fan motor bracket
may fall out.
Remove 2 screws from the fan motor bracket,
then remove the fan motor bracket.
Remove the wheel assembly by guiding the wheel
adjustment screw through the wheel adjustment
screw hole.
Adjustment screw
Screw
Connector
Motor
Screws
Grommet
Blades
Bracket
Icemaker
The orange and brown wires at the icemaker will
read 120 VAC.
Removal and Replacement
Switch
Bucket
Screw
Cover
Connector
Turn the icemaker switch to the OFF position.
Remove the icemaker bucket and cover.
Unplug the icemaker connector.
Remove 2 screws, then remove the icemaker.