GE GSS20 Series, Technical Service Manual

Page: 8 / 36

– 8 –
Circuit Board
The circuit board is located on the back side of
the refrigerator.
Removal and Replacement
To access the circuit board, remove 4 screws that
hold the circuit board cover in place and remove
the circuit board cover.
Pull the trim from the trim tab holes.
To install the dispenser trim, align the trim tabs
with the holes in the freezer door and press the
trim onto the freezer door.
Fresh Food Thermistors
The fresh food thermistors are located at the
upper and lower portions of the fresh food
compartment.
Removal and Replacement
With a small flat-blade screwdriver, unlock the
tabs and remove the assembly.
Remove the thermistor from the cover and
disconnect the wire connector.
Dispenser Trim
Removal and Replacement
To remove the dispenser trim, insert small flat-
blade screwdriver in the slots located at the
bottom of the trim and lift up.
Components
Disconnect 3 electrical connectors. Remove the 3
screws that hold the circuit board in place, then
remove the circuit board.
Cover
Connectors