GE GLDT690J__BB, Technical Service Manual, Page: 30 / 33

– 30 –
Self Diagnostic Mode
Self Diagnostic Mode will not display errors and other information available in Service Mode. It does allow
for up to 60 minutes of wash pump and heater operation. Service Mode should be run before entering Self
Diagnostic Mode.
To enter the 6HOI'LDJQRVWLF0RGH
1. Cancel any cycle started (including Delay Start ), and make sure that the dishwasher is in a standby or
LGOHVWDWH7KHGUDLQSXPSPXVW¿QLVKDVHFRQGUXQSHULRG
2. Disconnect power to the dishwasher for 30 seconds.
3. Within 3 minutes of reconnecting power, open the door and hold both the Select and Start/Reset pads
PXVWEHFRPSOHWHGZLWKLQVHFRQGV$OO/('VDQG66'ÀDVKDWUDWHRIVHFRQG
4. Close the door. If the door is opened during the diagnostic procedure, closing the door will restart the
test.
All cycle LED’s, Clean LED and Rinse LED will turn off, and display machine type for 2 seconds; then proceed
WRWKH¿UVWVWHS3UHVVLQJF\FOHVHOHFWGXULQJDQ\VWHSRIWKLVPRGHZLOODGYDQFHWKHFRQWUROWRWKHQH[WVWHS
when door closed. If the door is opened during this mode, the loads will stop immediately. The loads will
restart when the door is reclosed.
In step 4 (table below) if the temperature doesn't reach 122°F within 60 minutes, the error code "E3" will be
displayed on the SSD. If the temperature does reach 122°F, the load will stop and advance to step 5.
To exit the self diagnostic mode, disconnect the power.
*Subject to change with future development.
Step Component SSD Time or Temperature
0 Machine Type C9* 3 seconds
1 Fill Valve 09 61 seconds
2 Wash Pump 08 3 minutes
3 Dispenser 07 60 seconds
4 Wash Pump and Heater 06 60 minutes or 122°F
5 Drain Pump 05 60 seconds
6 All Load Off 04 15 seconds
7 Fill Valve 03 61 seconds
8 Wash Pump 02 180 seconds
9 Drain 01 60 seconds
10 Buzzer beep and End F_ Software Version, beeper 1/2 second