GE GFDN240ELWW, Service Manual

Page: 47 / 111

Copyright 2011
47
Installing the Drive Belt
1. Remove the front panel.
2. Reach under the left-hand side of
the drum, push the idler pulley down
and to the right, and lock the pulley
shaft on the top corner of the
motor bracket.
3. Place the belt in position around the
center of the drum through the front of
the dryer.
4. Place the belt in position around the
motor pulley (see diagram), release
the idler pulley from the motor bracket,
and guide onto the belt.
Note:
Check to make sure the belt is
in place and not twisted before
installing the top and front panels.
View from rear of dryer