GE GES-NIG25IN-20, Owner'S Manual And Installation Instructions

Page: 13 / 120

Indoor Unit Installation
Make holes of 60 mm in diamet er.
Ins tall piping hole cover and sea l it off with putty after installation
F itting of the Mounting P late and Positioning of the wall Hole
Making a Hole on the Wall
Indoor side
O utdoor side
Ø 60mm
Wall hole
T hickness of wall
(S ection of wall hole)
12
1. Fix mounting plate on the wall horizontally.
2. Positoning the piping hole at position shown at figure.
The different shape of mounting plate has its position.
1.
2.
3. F asten securely the plate with stee l nails o f the reference holes 1, 2 , 3
4. Che ck carefully to make s ure the installation s ecure.
P reparation of indoor unit body
1
2
3
1. Take out cushion blocks on the left and right angle beads as shown in
the following . The cushion blocks are no longer used.
2. Remove 2 cushions between the cross-flow fan and the casing
3. There are 3 virtual segments on the case. Select the required virtual
segment on the case according to the piping outside direction .
Remove it by hands
and clean the burr to let the power cable (with the plug)
pass through.
Preparation of piping and conne cting wiring 4
1
Cut the connecting wirings 1.5m longer than the pipe
length.
Cut the pipes a little longer than measured distance.
Measure the distance between the indoor and the
outdoor unit.
Use the accessory piping kit or the pipes.
Cut the pipes and cables
Turn the pipe end down to avoid the metal
powder entering the pipe.
2
Remove the burrs
3
Insert the flare nuts,mounted on the connection
Fit the copper end into the Bar of flare tool
Flare the pipe end.
Flaring the pipe.
Conne ction of piping
5
1.Align the center of the piping and sufficiently tighten
2.Finall y, tighten the flare nut with torque wrenchuntil
the wrench clicks.
When tightening the flare nut with torque wrench ,
ensure the direction for tightening follows the arro
w
on the wrench.
and 4. In case of left rear piping, please find the wall hole location A.
In case of right rear piping, please find the wall hole location C.
A=170mm
C=120mm
30
mm
30
mm
B= 60mm
B=60mm
1 2
3
4
500
144
3
5
70
2
5
1
3
5
183
500
76
60mm
60mm
60mm
60mm
GES-NJGB50IN
GES-NJGW50IN GES-NJGB50IN-20
GES-NJGW50IN-20 GES-NMG50IN
GES-NMG50IN-20
GES-NMG70IN GES-NMG70IN-20
GES-NJGB25IN-1
GES-NJGW25IN-1 GES-NJGB35IN-1
GES-NJGW35IN-1
GES-NJGB25IN-20
GES-NJGW25IN-20 GES-NJGB35IN-20
GES-NJGW35IN-20
GES-NMG25IN GES-NMG35IN
GES-NQG25IN GES-NQG35IN
GES-NMG25IN-20 GES-NMG35IN-20
GES-NIG25IN-20
GES-NIG35IN-20
GES-NM25IN M
GES-NM35IN M