GE GCRH410 Installation Instructions Manual Download Page 6

     

INSTALLATION (CON'T)

5.

Place the hook end of the drain hose in the drain opening.
Secure the drain hose with the cable tie (provided in the
enclosure package) to the standpipe, inlet hose, laundry
tub, etc. so the hose does not pull out from the force of the
water.

6.    Plug the power cord into a grounded outlet.

NOTE:

Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an
outlet.

7.    Turn on the power at a circuit breaker/fuse box.

8.

Read the Operating Instructions and Owner’s Guide provided
with the washer. They contain valuable and helpful information
that will save you time and money.

9.

Run the washer through a complete cycle. Check for water
leaks and proper operation.

10. If your washer does not operate, please review the “Avoid

Service Checklist” in your Owner’s Guide before calling for
service.

11. Place these instructions in a location near the washer for future

reference.

NOTE:

A wiring diagram and technical data sheet are located in
an envelope attached to the left hand side panel on the
inside of the washer.

                                  REPLACEMENT PARTS

If replacements parts are needed for your washer, contact the source
where you purchased your washer.

 Destroy the carton and plastic bags after the washer

is unpacked. Children might use them for play. Cartons covered
with rugs, bedspreads, or plastic sheets can become airtight
chambers causing suffocation. Place all materials in a garbage
container or make materials inaccessible to children.

 The instructions in this manual and all other literature

included with this washer are not meant to cover every possible
condition and situation that may occur. Good safe practice and
caution 

MUST

 be applied when installing, operating and

maintaining any appliance.

Maximum benefits and enjoyment are achieved when all the
Safety and Operating instructions are understood and practiced
as a routine with your laundering tasks.

Cable Tie

Cable Tie

Cable Tie

6

Pedestal

A pedestal accessory, 

Model No.

   

NLPWD15

, specifically designed for

this washer may be used when elevating the washer for ease of use.
Failure to use accessories certified by the manufacturer could result in
personal injury, property damage or damage to the washer.

Summary of Contents for GCRH410












Reviews: