MOUNTING
2
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 30 ft-lbs of torque on set screws
or 20 ft-lbs of torque on knuckle bolt.
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 20 ft-lbs of torque on knuckle bolt.
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 20 ft-lbs of torque on trunnion bolt.
• Inspect luminaire to confirm no damage has occurred
during transit.
• To avoid damage, do not impact or stack luminaire
after removal from packaging.
UNPACKING/HANDLING
1
Clearance hole for Customer
Supplied 3/4” Bolt
2a. Pipe Mount:
Mount on vertical 1-7/8 to 2-3/8-inch
O.D. or 2-3/8 to 3-inch O.D. pipes.
• Pipe must point upward such that gravity acts to hold
luminaire on pipe end.
• Do not mount unit upside down.
• Tighten set screws to 25-30 ft-lbs (34-41 N-m) of torque.
• Tighten Knuckle Bolt to 15 to 20 ft-lbs torque after aiming.
2b. Wall Mount:
Mount to vertical surface using four
0.43-inch clearance holes spaced 4.37(H) x 2.87(V) inches
with customer supplied fasteners/anchors.
• Seal wall mount flange to the mounting surface
with silicone caulk or equivalent.
• Tighten Knuckle Bolt to 15 to 20 ft-lbs torque after aiming.
2c. Trunnion Mount:
Mount on a flat surface using a
customer supplied 3/4-inch bolt through the clearnace
hole provided in the trunion bottom.
• Tighten two (2) side Trunion Bolts to 15 to 20 ft-lbs
torque after aiming.
• If desired, trunion can be secured against rotation
by using customer supplied fastner(s) through
additional clearance holes in the trunion bottom.
Wiring Cover
4.375 in.
4 Holes
.430 in.
2.875 in.
FIGURE 2. Wall Mount
FIGURE 3. Trunnion Mount
Set Screws
Wiring Cover
Knuckle Bolt
Door Hinge
Knuckle Bolt
Trunnion Bolt
Top Closure Screw
FIGURE 1. Pipe Mount
