GE EPM 5300, Instruction Manual

Page: 55 / 100

CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP
GE Multilin EPM 5000 series Advanced Power Meters
51
PROGRAMMING STEPS:
1. Enter in GROUP 0, FUNCTION 4, PACK ‘P’, Segment C and D: UP, UP.
2. Enter in GROUP 5, FUNCTION 4, LIMIT 1, Segments B, C, and D: DOWN, UP, DOWN. Value: 58.00.
3. Enter in GROUP 5, FUNCTION 4, LIMIT 2, Segments B, C, and D: UP, UP, DOWN. Value: 62.00.
Example 2:
Normally reset—non-event condition is reset relay
Relay 1 will be “SET” if the instantaneous reading for amps is below 4.00 or above 5.00 amps. Under all
other conditions the relay will be “RESET”.
NOTE: Under this setup the relay will NOT act as a protective switch.
4 . 0 0 A
5 . 0 0 A
0 . 0 0 A
S E T
S E T
L M 2
L M 1
R E S E T
N O P O W E R T O T H E U N I T
R E S E T
PROGRAMMING STEPS:
1. Enter in GROUP 0, FUNCTION 4, PACK ‘p’, Segments C and D: DOWN, DOWN
2. Enter in GROUP 4, FUNCTION 2, LIMIT 1, Segments: B, C, and D: UP, UP, DOWN. Value: 5.00
3. Enter in GROUP 4, FUNCTION 2, LIMIT 2, Segments: DOWN, UP, DOWN. Value: 4.00
GROUP 0—FUNCTION NUMBER DESCRIPTION
04.P Controls Relay 1
05.P Controls Relay 2 (and 3 if NL4)
Relay Mode: Group 0, Functions 4–5