DGT DISTRIBUTED GENERATION TRIP CONTROL SYSTEM – INSTRUCTION MANUAL
3–19
DGT Distributed Generation Trip
Control System
Chapter 3: User interface
GE Consumer & Industrial
Multilin
User interface
Transceiver layouts
DGT-U Transceiver layout
•
Power LED shall illuminate when power is applied to the radio.
•
The Link LED illuminates when the DGT-D transceiver has established a connection
with a DGT-R transceiver.
•
The Service (SERV) LED flashes whenever a transceiver alarm condition is detected or
if any of the configured outputs are in a failsafe state.
•
The input LED (IN) is illuminated whenever the trip status is energized.
•
The output LED (OUT-1) illuminates whenever the associated output is energized.
OUT-1 will reflect the state of the status input on the DGT-D radio configured for Slot 1
RF OUTPUT
◆
◆
Antenna Connector (TNC)
902 to 928 MHz (FHSS)
CONFIGURATION
ÊDCE Console/Terminal
◆
◆
19,200 bps/8N1 (Default)
No Handshaking
RS/EIA-232
◆
◆
1 to 4
5 to 8
TERMINATIONS
9 to 12
13 to 16
TERMINATIONS
LED PANEL
Power, Link, Inputs/Outputs
◆
(configurations vary)
+ Ð
Ð
+
PWR
LINK
SERV
IN
OUT-1
OUT-2
CONFIG
ANT
OUT-3
OUT-4
OUT-5
OUT-6
OUT-7
PRIMARY POWER
◆
13.8 Vdc @ 350 mA (6 to 30 Vdc)
Negative Ground
1 + / 2
◆
◆
-
24 VDC POWER OUTPUT
◆
◆
24.0 Vdc @ 40 mA
Isolated from Ground
Pins 3 (+) and 4 (-)
◆