– 45 –
Troubleshooting
The dryer control has a service test mode that can be utilized by the service technician in order to test
critical components and to access error codes. This test mode will help the service technician to quickly
identify failed or improperly operating dryer components.
To enter the test mode:
To exit the test mode:
With the power connected but the power button off,
within 3 seconds:
1. Press
the
SIGNAL
button.
2. Press
the
EXTEND TUMBLE
button.
3. Press
the
SIGNAL
button.
4. Press
the
EXTEND TUMBLE
button.
Upon entering the service test mode, the control
will be in test selection mode tO1. Rotating the knob
clockwise will increment the test numbers. Rotating
the knob counterclockwise will decrement the test
numbers. Scroll thru the list of tests by rotating the
knob CW or CCW.
Once the desired test is highlighted, press
START/
PAUSE
to begin the test.
During a test, press
POWER
to terminate it and go
back to test selection mode.
Press the
POWER
button during the test selection
mode to exit the service test mode.
Note:
A dryer left in the test mode will exit the test
mode after a period of approximately 15 minutes.
Service Test Mode
(Continued Next Page)
