6
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting Tips
About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
Control Settings
Status Indicator Lights
(Indicators vary by models)
The Status display tells you what is happening while the dishwasher is in operation and may flash, indicating
a malfunction. The lights will come
ON
indicating the sequence of the dishwasher operation.
LOW DETERGENT
Displayed when the SmartDispense
TM
needs to be refilled with liquid or gel automatic
dishwasher detergent.
NOTE:
If you are not using SmartDispense
TM
and you want to turn the
LOW DETERGENT
LED light off, press the
ADDED HEAT
button 5 times within 3 seconds. You will hear 3
beeps; then the light will go off. You can turn the light back on by pressing the
ADDED
HEAT
button 5 times within 3 seconds.
SENSING
Displayed while the Clean Sensor
TM
is measuring the amount of soil and temperature
of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
SANITIZED
Displayed at the end of the cycle when SANITIZE has been selected and the dishwasher
has met the requirements for sanitization. See SANITIZE, below, for complete cycle
description. Opening the door or pressing any key while the door is closed and latched
will turn off the light.
CLEAN
Displayed when a wash cycle is complete. Refer to Item 6, page 9, for further
explanation of clean light operation
CYCLE STATUS
The cycle status indicator light is located on the right side of the dishwasher, above the
INDICATOR
handle. This light comes on as amber while the selected cycle is running. The light turns
to green when the selected cycle is complete. The light stays
ON
as green as a reminder
that the dishes are clean until the door is opened or until another cycle is selected.
Time Remaining Display
(on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
NOTE:
This dishwasher is equipped with CleanSensor
TM
with automatic temperature control; therefore,
cycle length and time may vary depending on soil and water temperature conditions.
2
1
Front-Control Dishwashers
Top-Control Dishwashers
1
6
3
4
5
5
6
2
4
3
1
Cycle Status Indicator Light
